Introduction #
Thank you for purchasing an Electroconcept product.
Please read carefully the following guide before using DMX HF remote control V4.
Responsibility:
Electroconcept can’t be held responsible for any damage caused by a misuse of any kind such as loss of utilizing, consumable destruction (tapes, CDs, LED Strips, etc.) or any other financial loss due to an unappropriate use of our products or any impossibility to use them; so as any wiring mistake during the installation.
Guarantee:
Electroconcept products benefit from a two years manufacturer guarantee (electronic components only, except consumable ones e.g plastic components). The product must be returned to Electroconcept postage paid and in its original package. If not, the package will be refused and returned to sender. Electroconcept company is in charge of the product restitution.
Are excluded of the guarantee benefits the followings : any damage caused by carelessness, mistake, lack of maintenance by the user (broken, burned, heated, soaked, silted up, etc.); wrong installation or misuse by the user. All our products are tested before sending to buyers. Modifications of any kind are at your own risk and out of guarantee benefits.
Technical specifications #
- Produit complet avec batterie LI-ION 900 mAH intégrée.
- Alimentation : 5 V DC via cordon Jack et bloc secteur
- Consommation : 300 mA en charge, 12 mA en fonctionnement normal
- Dimensions : 105 mm X 30 mm X 25 mm (hors antenne)
- Sensibilité HF (2.4Ghz) : – 100 db
- Fréquence : 21
- Univers possibles : 31 (15872 canaux DMX)
- Protocole W2.4EC-DMX-A ET B
- Autonomie : 50 h environ
- Sortie XLR 3 points
The range depends on the environment, approximately 30 m in hostile environments (between thick walls, for example) and approximately 600 m outdoors.
Default configuration #
Each receiver contains a memory that allows to send back the last value received when there is a loss of HF connection.
By default, remote controls are configured on universe ID 1.
Utilisation #
Using HF Electroconcept products doesn’t alter the way your DMX devices are used.
The technology used allows to have a complete transparency between your devices.
The 512 channels are sent. Frames synchronisation allows to avoid latency between the emittor and the receiver.
Connect your DMX devices on the remote control DMX Output, XLR 3-pin female. The remote control.s as well as the emitter you are using should be configured on the same universe ID. For optimal performance, a maximum of 5 devices is recommended. Beyond this, use a Spitter Booster.
- In battery mode, switch the switch button on the side on “BATT”..
- In power supply mode, we recommend switching the switch to the same side. This means that if there is a problem, the battery automatically takes over.
- To switch off your remote control, unplug the power supply then press and hold the switch button “ON/OFF”.
LED #
The blue LED “BAT” is switched on when the battery is charging.
The orange LED “DMX” flashes at the rate of the DMX signal frames sent to the XLR output
The red LED “HF” shows the status of HF signal:
- slow flashing : no DMX HF signal, waiting for universe ID data
- fixed or flashing very fast: signal DMX HF signal detected with satisfactory signal
- flickering LED or irregular flashing rhythm: low DMX HF signal detected, DMX frames are incomplete and are supplemented by the latest values received.
